How To Reset Your Madison Home System
A nice benefit of having your home security hooked up by trained experts is that you rarely need to make major adjustments to it. However, there may be times where you have to reset your alarms in Madison. If you use the ADT Command hub, resetting normally requires just one or two tap of a button following occurrences like battery changes, power outages, and false alarms.
Check Your Instruction Manual Before Attempting An Alarm Reset
A word to the wise before you begin to reset your Madison home security system, check your manual first. You don't want to compromise your property’s defense because you hit something incorrectly. Additionally, control panels could be different if you switched from a number pad to a modernized touchscreen interface. If there’s ever a time when you’re unable to figure out how to reset your system, don't hesitate to contact the professionals.
Resetting Your Madison Home Security System Because Of A False Alarm
Generally, a false alarm happens as a result of a sensor that was tripped by accident. You can use the control panel or access your ADT security app and tap the shield icon and submit your security code to deactivate the system in these situations. You may get a call from your security monitoring team, but just tell them it was a false alarm.
How To Reset Your Alarm Following A Power Outage In Madison
If the power goes out from a storm or other event, you might start hearing a steady beep from your central command hub. This lets you know that your home’s defense is running off the secondary power source. To reset your equipment and silence the steady beeps, you should deactivate and reactivate your system.
However, if power is out for prolonged time frame, you may need a full system reset. Follow the instructions in the instruction manual -- typically by submitting your code and pressing the designated button twice -- and you should be running fine. You could keep hearing chirping caused by the secondary power source, as it may not end until the battery charges entirely. Contact your home security specialists if you keep having difficulties with your ADT equipment 20 hours after power is restored.
How To Reset Your Home Security System After Switching Out A Battery
Occasionally you must change a battery in one of the devices in your security installation. When this needs to be done, you want to switch your home’s defense to test mode so you prevent setting off an alarm by accident. When the new battery is put in place, remove the system out of "Test Mode" and revert back to your usual settings. If the command center is unable to recognize the piece of equipment or the battery light remains on, you could need a full reset of your security system.
Tips to Reset Your Madison Security System After Adding Or Deleting A User
The addition and deletion of people can be accomplished on your ADT Command interface and the ADT Control mobile app. You should never have to perform a system reset following the addition or deletion of a user or code. But you should note, if you relocate to a new property with an existing ADT system, you should reach out to your residential security experts at (608) 424-5550 to establish a new plan. The installation tech will go on site to switch out components, place more alarms or cameras (as required), and reset the system for you.
A User-Friendly Security System Is Only A Call Away
Attempting to reset a home security system in Madison can be a challenge if it fails to include understandable equipment and instructions. If you would like to find your intuitive alarm system, dial (608) 424-5550 or send in the form below. Our specialists are happy to help customize the perfect security system for your needs.